Simulation error

[Mudit Mohan Das]

Hi,
I am new to MagCAD. I wanted to simulate a simple circuit but there was an error while exporting vhdl. I went through the log file but I can’t figure out how to rectify the error. Please help.

• This topic was modified 5 years, 8 months ago by Mudit Mohan Das.

Attachments:

1. 

   error.png
   

1. pNML1.qll
2. pNML1-1.qll

[Fabrizio]

Hi,

you are getting the error to the pad in coordinate x=2, y=3 because you cannot connect to another pad. If you look at the documentation you can find the connectivity options for every element. Why would you couple three pads together? Move forward the two pads around the nucleation center and your issue will be solved.
Remember also to assign an output pin to the circuit.

Fabrizio

• This reply was modified 5 years, 8 months ago by Umberto.

[Mudit Mohan Das]

Can we edit the design which we made previously because when I open my previous project and try to edit the design like removing the parts , then the parts are not selected. I am unable the previous parts. Please help.

[Umberto]

Hi,
you can edit your layout but you can’t edit the component that you exported. Open the layout, modify what you need and then export again the component.

Regards,
Umberto

[Author]

Posts